• grandMA3 User Manual
  • grandMA3 Quick Start Guide
  • grandMA3 Quick Manual consoles
  • grandMA3 Quick Manual processing units
    • Intended Use
    • Safety
    • Support
    • Transport
    • Limitations
    • Quick Start
    • Maintenance
    • Disposal
    • Technical Data
    • Conformity
  • grandMA3 Quick Manual Nodes
  • grandMA3 Quick Manual Nodes DIN-Rail
  • grandMA3 Quick Manual onPC command wing XT
  • grandMA3 Quick Manual onPC command wing
  • grandMA3 Quick Manual onPC fader wing
  • grandMA3 Quick Manual onPC rack-unit
  • grandMA3 Quick Manual viz-key
  • grandMA3 Quick Manual I/O Nodes
  • Release Notes
Select different version
 
Version 1.8

Technical Data

Important:
Only use adequately protected power cables (min. Ø = 3 x 1.0 mm²).
The required power cable must meet the country's standards.
Only qualified personnel is allowed to perform work on the power cable!
Important:
Power cable and connector are not included in the delivery.
Hint:
The processing units M, L, XL have an equal front panel and rear panel.
  • DMX: max. length of the cable 350 m (in ideal conditions).
  • Use CAT-5e Ethernet cable or higher. Max. length of the cable 75 m.
grandMA3 processing unit front panel
Technical Data grandMA3 processing unit M, L, XL  
Operating voltage 100-240 V AC, 50/60 Hz
Net weight 5 kg / 12 lbs
Power max. 200 VA
Dimensions 482 x 372 x 87 mm / 19 x 15 x 4 in (width x depth x height)
Parameters  
grandMA3 processing unit M 4 096
grandMA3 processing unit L 8 192
grandMA3 processing unit XL 16 384

Outputs grandMA3 processing unit M, L, XL

grandMA3 processing unit rear panel
Number Connector
1 x powerCON TRUE1 (registered trademark of Neutrik AG, Liechtenstein)
2 x etherCON/RJ45
8 x DMX512-A OUT (5pin XLR female)
3 x USB 2.0 (type A)

Select different version