• grandMA3 User Manual
  • grandMA3 Quick Manual consoles
  • grandMA3 Quick Manual processing
  • grandMA3 Quick Manual nodes
  • grandMA3 Quick Manual DIN-Rail
  • grandMA3 Quick Manual onPC command wing XT
    • Intended Use
    • Safety
    • Support
    • Transport
    • Limitations
    • Quick Start
    • Maintenance
    • Disposal
    • Technical Data
    • Conformity
  • grandMA3 Quick Manual onPC command wing
  • Release Notes
Select different version
 
Hint:
New help version
The help version you selected belongs to an older software version. You may want to view the latest help version.
Version 1.2

Quick Start

Table of contents of this topic

hide

  1. Power key
  2. Level wheel
  3. Command section
  4. Master section
  5. Executor buttons
  6. Executor faders
  7. Executor buttons
  8. Executor knobs
  9. Dual encoder section

Connect and Power Up the Device

  1. Unpack the device.
  2. Remove the packaging and cushioning material.
  3. Place the device indoors on an stable surface.
  4. Connect external monitors to the console using a native DisplayPort connector. 
  5. Start the grandMA3 onPC command wing XT:
    -Insert the IEC connector into the corresponding jack. 
    -Connect the power plug.
    -Turn on the power switch:
    -Set the power switch to position I. 
    -The power switch lights up in red.
    -Press the power key on the front panel. 
    -The device starts booting.

Turn off the grandMA3 onPC command wing XT

To turn off the grandMA3 onPC command wing XT:
-Press the power key on the front panel.

 

-A warning pop-up appears:

-Tap OK.
-The grandMA3 onPC command wing XT powers down.

Important:
Do not switch off the grandMA3 onPC command wing XT too early. 
Make sure that you wait until Windows has completely shutdown.
All LEDs on the grandMA3 onPC command wing XT must have turned off.

-Set the power switch to position O. 

-Show data is only saved in the grandMA3 onPC software.
-For updates use the grandMA3 onPC software.
Important:
You can disconnect the grandMA3 onPC command wing XT using the grandMA3 onPC software. The DMX output will then be interrupted immediately. 

Different Combinations

Device Connected To Parameters
grandMA3 onPC command wing XT + PC/laptop 4,096
grandMA3 onPC command wing XT + PC/laptop + grandMA3 onPC 8/4/2Port Node 4,096
grandMA3 onPC command wing XT + PC/laptop + grandMA3 processing unit M/L/XL 4,096
 
Important:
Independent of the devices connected to the grandMA3 onPC command wing XT, the number of parameters can only reach a maximum of 4,096. 

For more information see: Expand the Amount of Parameters topic.


Select different version