- grandMA3 User Manual
- grandMA3 Quick Start Guide
- grandMA3 Quick Manual consoles
- grandMA3 Quick Manual processing units
- grandMA3 Quick Manual Nodes
- grandMA3 Quick Manual Nodes DIN-Rail
- grandMA3 Quick Manual onPC command wing XT
- grandMA3 Quick Manual onPC command wing
- Intended Use
- Safety
- Support
- Transport
- Limitations
- Quick Start
- Maintenance
- Disposal
- Technical Data
- Hardware-related Instances
- Conformity
- grandMA3 Quick Manual onPC fader wing
- grandMA3 Quick Manual onPC rack-unit
- grandMA3 Quick Manual viz-key
- grandMA3 Quick Manual I/O Nodes
- Release Notes
Version 1.9
Quick Start
- Master area
- Dual encoder section
- Command area
- Level wheel
- Executor buttons 101-190 + 201-290
- Executor faders 201-290
- Executor buttons 301-390 + 401-490
- Executor knobs 301-390 + 401-490
For more information about executors, see Executor elements.
- DMX A, B, C
- MIDI In+Out
- DC Remote Control
- LTC
- USB
- Power switch
- IEC connector
- Desk light
- Kensington lock
Turn on the grandMA3 onPC command wing
- Unpack the device.
- Remove the packaging and cushioning material.
- Place the device indoors on a stable surface.
- Download the grandMA3 onPC software on www.malighting.com
- Install the software on your PC or laptop. For minimum requirements see System Requirements grandMA3 in the grandMA3 user manual.
- Connect the grandMA3 onPC command wing with your PC or laptop using a USB cable.
- Start the grandMA3 console or grandMA3 onPC software.
- Insert the power connector into the corresponding jack.
- Connect the power plug with the mains.
- Turn on the power switch on the rear panel.
The device starts booting.
To turn off the grandMA3 onPC command wing set the power switch to position O.
Important:
-Show data is only saved in the grandMA3 onPC software.
-For updates use the grandMA3 onPC software.
-Show data is only saved in the grandMA3 onPC software.
-For updates use the grandMA3 onPC software.
Important:
You can disconnect the grandMA3 onPC command wing using the grandMA3 onPC software. The DMX output will then be interrupted immediately.
You can disconnect the grandMA3 onPC command wing using the grandMA3 onPC software. The DMX output will then be interrupted immediately.
Different Combinations
Device | Connected To | Parameters |
---|---|---|
grandMA3 onPC command wing + | PC/laptop | 4 096 |
grandMA3 onPC command wing + | PC/laptop + grandMA3 onPC 8/4/2Port Node | 4 096 |
grandMA3 onPC command wing + | PC/laptop + grandMA3 processing unit M/L/XL | 4 096 |
Important:
Independent of the devices connected to the grandMA3 onPC software, the number of parameters can only reach a maximum of 4 096.
Independent of the devices connected to the grandMA3 onPC software, the number of parameters can only reach a maximum of 4 096.