• grandMA3 User Manual
  • grandMA3 Quick Manual consoles
  • grandMA3 Quick Manual nodes
  • grandMA3 Quick Manual processing
  • grandMA3 Quick Manual onPC solutions
    • Intended Use
    • Safety
    • Support
    • Transport
    • Limitations
    • Quick Start
    • Maintenance
    • Disposal
    • Technical Data
    • Conformity
  • grandMA3 Quick Manual DIN-Rail
  • Release Notes
Select different version
 
Version 1.0

Quick Start

grandMA3 onPC command wing front panel
  1. Dual encoder section
  2. Level wheel
  3. Command section
  4. Master section
  5. Executor buttons
  6. Executor faders
  7. Executor buttons
  8. Executor knobs

Connect and Power Up the Device

  1. Unpack the device.
  2. Remove the packaging and cushioning material. 
  3. Place the device indoors on a stable surface. 
  4. Download the grandMA3 onPC software on www.malighting.com
  5. Install the software on your PC or laptop. For minimum requirements see System Requirements grandMA3 in the grandMA3 user manual. 
  6. Connect the grandMA3 onPC command wing with your PC or laptop using a USB cable.
  7. Start the grandMA3 console or grandMA3 onPC. 
  8. Switch on the grandMA3 onPC command wing: 
    -Insert IEC connector into the corresponding jack. 
    -Connect the main power plug. 
    -Turn on the power switch:
    -Set it to position I
    -The power switch lights up in red.

To turn off the grandMA3 onPC command wing set the power switch to position O

Important:
-Show data is only saved in the grandMA3 onPC software.
-For updates use the grandMA3 onPC software.
Important:
You can disconnect the grandMA3 onPC command wing using the grandMA3 onPC software. The DMX output will then be interrupted immediately. 

Different Possibilities of Combination

Device Connected To Parameters
grandMA3 onPC command wing + PC/laptop 2,048
grandMA3 onPC command wing + PC/laptop + grandMA3 8/4/2Port Node 4,096
grandMA3 onPC command wing + PC/laptop + grandMA3 processing unit M/L/XL 4,096
Important:
Independent of the devices connected to the grandMA3 onPC command wing, the number of parameters can only reach a maximum of 4,096. 

Select different version