MA Network Switch
- Introduction
  - Intended Use
  - Dangers caused by Electric Current
  - General Safety Instructions
  - System Requirements
  - SFP Transceiver Compatibility
- Device Overview
  - Front Panel
  - Rear Panel
  - LED Indicators
  - Factory Defaults
- First Steps
  - Unpack the Device
  - Install Mini-GBIC (SFP)
  - Installation in a Rack
  - Connect the Hardware
  - Set the IP Address on the PC
  - Access the Web Interface
- Display Navigation
  - Groups View
  - Workload View
  - Reset View
- Ports / Groups
  - Change Port Description
  - Assign Groups to Ports
  - Edit RSTP
  - Edit Speed Setting
  - Change Group Name
  - Edit IGMP Snooping
  - Edit IGMP Querier
  - Edit Unknown Flooding
  - Change VLAN ID
- Presets / Filters
  - Assign Presets to Ports
  - Apply Filters to Ports
  - Create New Presets
  - Update Presets
  - Create New Filter
  - View Filters
  - Delete Presets
  - Delete Filter
- General Settings
  - Change Name
  - Change ID
  - Change DHCP Client
  - Change IP Address
  - Change Subnet Mask
  - Change Default Gateway
  - Change Password
  - Update Firmware
  - Fallback to Backup Firmware
  - Get Switch Configuration
  - Upload Switch Configuration
  - Reset Settings
- Specifications
- Support
- Glossary

Hint:
New help version
The help version you selected belongs to an older software version. You may want to view the latest help version.

Version 3.1

Update Presets

You can modify the filter assignment for existing preset and update them.

Requirement: Applied preset to a port.

Click Edit Presets and then click Extended filter and preset config.
Modify the filter assignment for the preset in the assigned port column.
Click Save as preset at the end of the port column.
The save presets pop-up opens.

Figure: Update Preset
Select in the drop down the preset you want to update.
Click Update existing preset.

The preset is updated with the new filter assignment and saved in the startup configuration.