• MA Network Switch
    • Introduction
      • Intended Use
      • Dangers caused by Electric Current
      • General Safety Instructions
      • System Requirements
      • SFP Transceiver Compatibility
    • Device Overview
      • Front Panel
      • Rear Panel
      • LED Indicators
      • Factory Defaults
    • First Steps
      • Unpack the Device
      • Install Mini-GBIC (SFP)
      • Installation in a Rack
      • Connect the Hardware
      • Set the IP Address on the PC
      • Access the Web Interface
    • Display Navigation
      • Groups View
      • Name View
      • Workload View
      • LAG View
      • Reset View
    • Ports / Groups
      • Change Port Description
      • Assign Groups to Ports
      • Edit LAGs
      • Edit RSTP
      • Edit Speed Setting
      • Change Group Name
      • Edit IGMP Snooping
      • Edit IGMP Querier
      • Edit Unknown Flooding
      • Change VLAN ID
    • Presets / Filters
      • Assign Presets to Ports
      • Apply Filters to Ports
      • Create New Presets
      • Update Presets
      • Create New Filter
      • View Filters
      • Delete Presets
      • Delete Filter
    • General Settings
      • Change Name
      • Change ID
      • Change DHCP Client
      • Change IP Address
      • Change Subnet Mask
      • Change Default Gateway
      • Change Password
      • Update Firmware
      • Fallback to Backup Firmware
      • Get Switch Configuration
      • Edit Port Mirroring
      • Upload Switch Configuration
      • Reset Settings
      • Web Interface and grandMA2
    • Specifications
    • Support
    • Glossary
Select different version
 
Hint:
New help version
The help version you selected belongs to an older software version. You may want to view the latest help version.
Version 3.3

Edit IGMP Querier

Important:
IGMP snooping requires at least one switch in a group (VLAN) to act as a querier, to ensure IGMP snooping functionality.

Querier register the multicast packets to the corresponding ports.
If more than one querier is activated per group, the switch with the lowest IP address will be elected as querier.
This election process is automated.

IGMP querier is disabled by default.

Requirement: Connection to the web interface.

  1. Click Edit Ports / Groups.
  2. Click in the IGMP Querier column, that box you want to enable or disable.
  3. Click Apply settings and stay where you are or Apply settings and leave edit.

IGMP querier is enabled or disabled for the selected group and saved in the startup configuration.


Select different version