• MA Network Switch
    • Introduction
      • Intended Use
      • Dangers caused by Electric Current
      • General Safety Instructions
      • System Requirements
      • SFP Transceiver Compatibility
    • Device Overview
      • Front Panel
      • Rear Panel
      • LED Indicators
      • Factory Defaults
    • First Steps
      • Unpack the Device
      • Install Mini-GBIC (SFP)
      • Installation in a Rack
      • Connect the Hardware
      • Set the IP Address on the PC
      • Access the Web Interface
    • Display Navigation
      • Groups View
      • Name View
      • Workload View
      • LAG View
      • Reset View
    • Ports / Groups
      • Change Port Description
      • Assign Groups to Ports
      • Edit LAGs
      • Edit RSTP
      • Edit Speed Setting
      • Change Group Name
      • Edit IGMP Snooping
      • Edit IGMP Querier
      • Edit Unknown Flooding
      • Change VLAN ID
    • Presets / Filters
      • Assign Presets to Ports
      • Apply Filters to Ports
      • Create New Presets
      • Update Presets
      • Create New Filter
      • View Filters
      • Delete Presets
      • Delete Filter
    • General Settings
      • Change Name
      • Change ID
      • Change DHCP Client
      • Change IP Address
      • Change Subnet Mask
      • Change Default Gateway
      • Change Password
      • Update Firmware
      • Fallback to Backup Firmware
      • Get Switch Configuration
      • Edit Port Mirroring
      • Upload Switch Configuration
      • Reset Settings
      • Web Interface and grandMA2
    • Specifications
    • Support
    • Glossary
Select different version
 
Hint:
New help version
The help version you selected belongs to an older software version. You may want to view the latest help version.
Version 3.3

Change IP Address

You can change the IP address of the MA Network Switch.
The IP address will be used to reach the web interface.
The current IP address is displayed at the upper right corner of the front display and in the title bar of the web interface.

Important:
If you change the IP address and the new IP address is within another subnet, it is necessary to set the IP address on your computer to connect to the web interface.
If the computer and the switch are in different subnet, the connection to the web interface is not possible.
Important:
Make sure that every device in the network has its unique IP address. If two devices have the same IP address in a network, the devices might not be reachable.

Requirement: Connection to the web interface.

  1. Click Tools / Edit General Settings.
  2. Type the new IP address in the IP address field.
  3. Click Apply settings and stay where you are or Apply settings and leave edit.
    The new IP address is displayed at the front end display of the switch.

The IP address is changed and saved in the startup configuration. To access the web interface, type the new IP address in the address field of the browser and press Enter.


Select different version