• MA Network Switch
    • Introduction
      • Intended Use
      • Dangers caused by Electric Current
      • General Safety Instructions
      • System Requirements
      • SFP Transceiver Compatibility
    • Device Overview
      • Front Panel
      • Rear Panel
      • LED Indicators
      • Factory Defaults
    • First Steps
      • Unpack the Device
      • Install Mini-GBIC (SFP)
      • Installation in a Rack
      • Connect the Hardware
      • Set the IP Address on the PC
      • Access the Web Interface
    • Display Navigation
      • Groups View
      • Name View
      • Workload View
      • LAG View
      • Reset View
    • Ports / Groups
      • Change Port Description
      • Assign Groups to Ports
      • Edit LAGs
      • Edit RSTP
      • Edit Speed Setting
      • Change Group Name
      • Edit IGMP Snooping
      • Edit IGMP Querier
      • Edit Unknown Flooding
      • Change VLAN ID
    • Presets / Filters
      • Assign Presets to Ports
      • Apply Filters to Ports
      • Create New Presets
      • Update Presets
      • Create New Filter
      • View Filters
      • Delete Presets
      • Delete Filter
    • General Settings
      • Change Name
      • Change ID
      • Change DHCP Client
      • Change IP Address
      • Change Subnet Mask
      • Change Default Gateway
      • Change Password
      • Update Firmware
      • Fallback to Backup Firmware
      • Get Switch Configuration
      • Edit Port Mirroring
      • Upload Switch Configuration
      • Reset Settings
      • Web Interface and grandMA2
    • Specifications
    • Support
    • Glossary
Select different version
 
Hint:
New help version
The help version you selected belongs to an older software version. You may want to view the latest help version.
Version 3.3

Edit RSTP

Table of contents of this topic

Rapid Spanning Tree Protocol (RSTP) uses point-to-point wiring and provides rapid convergence of the spanning tree.

If there are more than one point-to-point connections between two switches, RSTP manages the redundant link unless the original connection fails.

Important:
The MA Network Switch supports an implementation of RSTP that is compatible with the IEEE 802.1w standard and that does not support RSTP per VLAN. This means that the MA Network Switch sends and expects to receive untagged RSTP messages.
Edit RSTP

By default, RSTP is enabled.

  • Disabled = Red dot
    The switch does not run RSTP for this port. If RSTP is disabled, LLDP (Link Layer Discovery Protocol) is disabled as well.
  • Enabled = Green dot
    The switch runs RSTP for this port. If RSTP is enabled, LLDP (Link Layer Discovery Protocol) is enabled as well.

If RSTP is enabled, it either displays:

  • active:
    The MA Network Switch uses the connection.

-or-

  • blocking:
    The MA Network Switch blocks the connection.
Hint:
If the original connection (active) is interrupted, the redundant link (blocking) is set to active.

Requirement: Connection to the web interface.

  1. Click Edit Ports / Groups.
  2. To enable or disable RSTP, click the RSTP box of the corresponding port.
  3. Click Apply settings and stay where you are or Apply settings and leave edit.

RSTP is enabled (no icon) or disabled (indicated by a red R in the Groups View, Name View, LAG View) in the port you have selected and its settings are saved in the startup configuration.

Example

If you accidentally have connected two MA Network Switches with two Trunk ports. And you have more than one connection between two devices, then RSTP is required. If you then disable RSTP, there is no connection.


Select different version