• MA Network Switch
    • Introduction
      • Intended Use
      • Dangers caused by Electric Current
      • General Safety Instructions
      • System Requirements
      • SFP Transceiver Compatibility
    • Device Overview
      • Front Panel
      • Rear Panel
      • LED Indicators
      • Factory Defaults
    • First Steps
      • Unpack the Device
      • Install Mini-GBIC (SFP)
      • Installation in a Rack
      • Connect the Hardware
      • Set the IP Address on the PC
      • Access the Web Interface
    • Display Navigation
      • Groups View
      • Name View
      • Workload View
      • LAG View
      • Reset View
    • Ports / Groups
      • Change Port Description
      • Assign Groups to Ports
      • Edit LAGs
      • Edit RSTP
      • Edit Speed Setting
      • Change Group Name
      • Edit IGMP Snooping
      • Edit IGMP Querier
      • Edit Unknown Flooding
      • Change VLAN ID
    • Presets / Filters
      • Assign Presets to Ports
      • Apply Filters to Ports
      • Create New Presets
      • Update Presets
      • Create New Filter
      • View Filters
      • Delete Presets
      • Delete Filter
    • General Settings
      • Change Name
      • Change ID
      • Change DHCP Client
      • Change IP Address
      • Change Subnet Mask
      • Change Default Gateway
      • Change SNMP Status
      • Change Password
      • Update Firmware
      • Fallback to Backup Firmware
      • Get Switch Configuration
      • Edit Port Mirroring
      • Upload Switch Configuration
      • Reset Settings
      • Web Interface and grandMA2
    • Specifications
    • Support
    • Glossary
Select different version
 
Hint:
New help version
The help version you selected belongs to an older software version. You may want to view the latest help version.
Version 3.7

Connect the Hardware

Table of contents of this topic

Requirement:
Shielded twisted pair cable with RJ45 connector, min. Cat 5e
- or -
etherCON cable with Neutrik etherCON connector.
 

Connection with a PC

  1. Plug in the power cable into the switch.
    The switch starts booting.
  2. Plug in a network cable into one of the Ethernet ports of the switch.
    For the PC connection and for further configuration, you have to use a manage group port. We recommend port 13 at the front.
  3. Plug in the other end of the network cable into the Ethernet port on the PC.
    A green or orange link LED on the switch indicates a successful connection.

The MA Network Switch is connected with the PC.

Connection with a grandMA2

  1. Plug in the power cable into the switch.
    The switch starts booting.
  2. Plug in a network cable into one of the Ethernet ports of the switch.
  3. Plug in the other end of the network cable into the Ethernet port 1 of the grandMA2 console.
    A green or orange link LED on the switch indicates a successful connection.

The MA Network Switch is connected with the grandMA2.


Select different version