• MA Network Switch
    • Introduction
      • Intended Use
      • Dangers caused by Electric Current
      • General Safety Instructions
      • System Requirements
      • SFP Transceiver Compatibility
    • Device Overview
      • Front Panel
      • Rear Panel
      • LED Indicators
      • Factory Defaults
    • First Steps
      • Unpack the Device
      • Install Mini-GBIC (SFP)
      • Installation in a Rack
      • Connect the Hardware
      • Set the IP Address on the PC
      • Access the Web Interface
    • Display Navigation
      • Groups View
      • Name View
      • Workload View
      • LAG View
      • Reset View
    • Ports / Groups
      • Change Port Description
      • Assign Groups to Ports
      • Edit LAGs
      • Edit RSTP
      • Edit Speed Setting
      • Change Group Name
      • Edit IGMP Snooping
      • Edit IGMP Querier
      • Edit Unknown Flooding
      • Change VLAN ID
    • Presets / Filters
      • Assign Presets to Ports
      • Apply Filters to Ports
      • Create New Presets
      • Update Presets
      • Create New Filter
      • View Filters
      • Delete Presets
      • Delete Filter
    • General Settings
      • Change Name
      • Change ID
      • Change DHCP Client
      • Change IP Address
      • Change Subnet Mask
      • Change Default Gateway
      • Change SNMP Status
      • Change Password
      • Update Firmware
      • Fallback to Backup Firmware
      • Get Switch Configuration
      • Edit Port Mirroring
      • Upload Switch Configuration
      • Reset Settings
      • Web Interface and grandMA2
    • Specifications
    • Support
    • Glossary
Select different version
 
There's no German translation of this page yet, so the English version is shown.
Hint:
New help version
The help version you selected belongs to an older software version. You may want to view the latest help version.
Version 3.7

Change VLAN ID

All groups of the switch have a default VLAN ID, except Trunk.
If you implement the switch in an existing network, it can be necessary to change the VLAN ID of the groups.
You can change the VLAN ID of group 1 through group 6. The VLAN ID of group 8 (= manage group) is 1 and fixed.
Possible VLAN IDs are from 1 to 4095.

Group Default VLAN ID
1 100
2 200
3 300
4 400
5 500
6 600
Important:
It is possible to use a single VLAN ID per group. As changing IDs is sequentially handled, changing the IDs from 100, 200, 300, 400, 500, 600 to 200, 300, 400, 500, 600, 700 only changes the last group. Therefore, the remaining groups have at least dual VLAN IDs for a short period of time. 
Important:
If you change the VLAN ID of a group, you need to change the VLAN ID of each switch using this group.
The VLAN IDs of the groups which should communicate with each other, have to be the same.
If the VLAN IDs of groups are not the same, they do not communicate with each other.

Requirement: Connection to the web interface.

  1. Click Edit Ports / Groups.
  2. Click edit right beside VLAN ID.
    The VLAN IDs are editable.
  3. In the VLAN ID column, delete the old VLAN ID of the group you want to change, and type in a new VLAN ID.
  4. Click Apply settings and stay where you are or Apply settings and leave edit.

The new VLAN ID for the group is applied and saved in the startup configuration.


Select different version