• MA Network Switch
    • Introduction
      • Intended Use
      • Dangers caused by Electric Current
      • General Safety Instructions
      • System Requirements
      • SFP Transceiver Compatibility
    • Device Overview
      • Front Panel
      • Rear Panel
      • LED Indicators
      • Factory Defaults
    • First Steps
      • Unpack the Device
      • Install Mini-GBIC (SFP)
      • Installation in a Rack
      • Connect the Hardware
      • Set the IP Address on the PC
      • Access the Web Interface
    • Display Navigation
      • Groups View
      • Name View
      • Workload View
      • LAG View
      • Reset View
    • Ports / Groups
      • Change Port Description
      • Assign Groups to Ports
      • Edit LAGs
      • Edit RSTP
      • Edit Speed Setting
      • Change Group Name
      • Edit IGMP Snooping
      • Edit IGMP Querier
      • Edit Unknown Flooding
      • Change VLAN ID
    • Presets / Filters
      • Assign Presets to Ports
      • Apply Filters to Ports
      • Create New Presets
      • Update Presets
      • Create New Filter
      • View Filters
      • Delete Presets
      • Delete Filter
    • General Settings
      • Change Name
      • Change ID
      • Change DHCP Client
      • Change IP Address
      • Change Subnet Mask
      • Change Default Gateway
      • Change SNMP Status
      • Change Password
      • Update Firmware
      • Fallback to Backup Firmware
      • Get Switch Configuration
      • Edit Port Mirroring
      • Upload Switch Configuration
      • Reset Settings
      • Web Interface and grandMA2
    • Specifications
    • Support
    • Glossary
Select different version
 
There's no German translation of this page yet, so the English version is shown.
Hint:
New help version
The help version you selected belongs to an older software version. You may want to view the latest help version.
Version 3.7

Change Port Description

To have a better overview about what is connected to what port you can change the port description of each port.


Change Port Description

The port description has a maximum length of 8 characters.

The following characters are allowed:

  • Upper case letters A...Z
  • Lower case letters a...z
  • Numbers 0...9
  • Spaces, minus (-), plus (+), underscore (_)

Requirement: Connection to the web interface.

  1. Click Edit Ports / Groups.
  2. Type the port description in the description box below the port number.
  3. Click Apply settings and stay where you are or Apply settings and leave edit.

The port description is applied and saved in the startup configuration. The port description is visible in the web interface overview.

 


Select different version